一氧化碳侦测器 TS-5100 产品简介
自动吸入式气体侦测器 TS-5100 Series
-侦测气体种类: 氢气侦测器(H2)
-连续吸入泄漏毒性气体 及危险地带气体进行侦测。
-内置高性能自动吸入式微型泵,维护简便。
-3线制,安装简便,安装费用低。
-显示部份不但显示侦测器的工作状态,还以数字方式
显示气体泄漏程度。
-侦测毒性气体,*大的限度内发挥选择性佳。
-产品性能稳定佳,性能好。
-4-20mA标准输出信号,*长输出距离可达2500M。
-根据现场实际情况,可选择各种附件,(如过滤器,档
泥板,遮雨板)。
-可现场设定,单人就能够独立完成校正及维护。
产品规格
检测原理
电化学级傅传感式
侦测种类
LNG瓦斯、H2氢气、O3臭气、N2O笑气、CO一氧化碳、SF6六氟化硫、CF4四氟化碳、F2氟气、CH3F三氟甲烷、C2HCL3三氯乙烯、丙烷、SIH4硅甲烷、
侦测范围
0~9999ppm
操作温度/溼度
-20 ~ 50℃ / 10 ~ 90% RH
精 度
*大误差 ± 3% 以内
输出信号
DC4 - 20mA.R9-485(可选择)
警报设定
0~9999ppm 任意设定(1段 , 2段设定)
复位方式
手动复位或重新启动
警报方式
分段警报 (1段 , 2段设定)
警报状态
连续红灯
故障状态
连续黄灯
警报继电器输出
1段 , 2段继电器容量均为AC25V 1A
工作电压及电流
DC 24V± 10% 230 mA ma
產品規格 PRODUCT SPECIFICATION Sensor Type: Continuous auto sampling Function: Local FND display type Service: Indoor locations Measuring range: PPB, PPM & Vol.% Sensor life: 2 to 3 years typical Accuracy: ± 3% of full scale Response time: T90 < 45 sec. Zero drift: Less than 3% of full scale per year Suction flow method: Electrical diaphragm pump Flow rate: 0-2000 ml/min Max. Warranty: One year Approval: Alarm Signal:Cable Requirements: Digital communication: Baud Rate: Parity: Date Bits: CE/ USTC ENVIRONMENTAL SPECIFICATION MECHANICAL SPECIFICATION ELECTRICAL SPECIFICATION Input Power: 24V.DC normal Output Signal: 4-20mA (600 ohms max. load) 2 × SPDT 3-wire shield cable. Max distance 2500M RS-485 MODBUS Stop Bits: 1 9600 Even 8 Features - Semi-conductor Process gas detection solution CVD & oxidation gases, Doping gases, Etching & chamber cleaning 型錄
Intelligent gas detector
Transmitter type
Non-hazardous areas
Refer to Ordering InformationOperating Temperature range: Electronics -40℃ to 70℃
Standard sensor -50℃ to 80℃Storage Temperature range: -40℃ to 70℃ Operating Humidity range: 5 to 100% RH Operating Pressure range: ATM. ± 10% Weight: 1.5kg Material (housing): Steel Material (Enclosure): PTFE Mounting Type: Surface mount
18 to 27V.DC/230mA max.
Malfunction 2mA
Setup mode 2mA
Calibration 0mA
gases
- Intelligent-Type Gas Detector, having a Built-in Micro processor
- Continuous Measuring of Oxygen & Toxic Gas and Vapours by continuous sampling
- Excellent Measurement Sensitivity and Stability
- Warning, Alarm & Fault Relays
- Calibration Maintenance & Normal Measurement Modes
- RS-485 MODBUS communication
- Local FND display
- Control and Set up by key Switch on the Front
- Built-in Subminiature and High-Efficient Micro pump
- 3-wires connection
- 4-20mA Signal output
- Calibration by One Person and Easy Maintenance