氧气侦测器 TS-4100P 产品简介
自动吸入式气体侦测器 TS-4100P
-防爆型防爆结构,连续吸入泄漏可燃性气体及毒性气体进行侦测。
-内置高性能自动吸入式微型泵,对于在高温、潮湿、高压、高地安装管道的工作环境,连续吸入泄漏气体进行侦测。
-3线自动吸入方式与目前使用的5~6线吸入方式相比,安装简便,安装费用低。
-显示部份不但显示侦测器的工作状态,还以数字方式显示气体泄漏程度。
-产品性能稳定,寿命长,灵敏度高,选择性强,性能好的特点。
-*大的限度内降低因温度、湿度、压力、电等..外部因素带来的干扰。
-4-20mA标准输出信号,*长输出距离可达2000M。
-可现场设定,单人就能够独立完成校正及维护。
-侦测氧气、毒性气体、量大限度内降低混合气体带来的干扰,具优良选择性。
产品规格
适用种类
可燃性气体,毒性气体
侦测种类
O2氧气、NH9、CO一氧化碳、CL2、H2S硫化氢、SO2二氧化硫、NO一氧化氮、HCL氯化氢(盐酸)、NCN氢氰酸、NO2 二氧化氮
显示方式
LCD数码
检测型式
自动吸入式
检测原理
电化学式
量 程
0-100%leLEL & 0 - 100% VO ume
反应时间
在45秒以内
精 度
*大误差 ± 3% 以内
流量调整
300~2500 ml / min
气体连接管
1/4" Luivu
侦测范围
100M以内
操作温度
-20 ~ 50℃
操作溼度
10 ~ 90% RH
输出信号
4 - 20mA.DC/
接线要求
CVVS or CVVSB 1.25sq x 2Wire
传输距离
2000m 以内
供 电
DC 24V± 10% 250 mA mox
接口尺寸
1/2" or 3/4" PE / NPT.
防爆等级
Exd llC T6 產品規格 PRODUCT SPECIFICATION Sensor Type: Continuous auto sampling Function: Local FND display type Service: Indoor locations Measuring range: PPB, PPM & Vol.% Sensor life: 2 to 3 years typical Accuracy: ± 3% of full scale Response time: T90 < 45 sec. Zero drift: Less than 3% of full scale per year Suction flow method: Electrical diaphragm pump Flow rate: 0-1000 ml/min Max. Warranty: One year Approval: Ex d IIB T5 ENVIRONMENTAL SPECIFICATION Operating Temperature range: Electronics -20℃ to 50℃ Storage Temperature range: 0℃ to 40℃ Operating Humidity range: 15 to 90% RH Operating Pressure range: ATM. ± 10% MECHANICAL SPECIFICATION Weight: 1.5kg Material (housing): Steel Material (Enclosure): PTFE Mounting Type: Wall mount ELECTRICAL SPECIFICATION Input Power: 24V.DC ± 10% / 230mA max. Output Signal: 4-20mA(600 ohms max. load) 2 × SPDT 3-wire shield cable. Max distance 2000M RS-485 MODBUS (option) 9600 Even 8 Features - Flame proof type 型錄
Intelligent gas detector
Transmitter type
hazardous areas
Refer to Ordering InformationAlarm Signal:
Standard sensor -20℃ to 50℃
Malfunction 2mA
Setup mode 3mA
Calibration 3mA
- Semi-conductor Process gas detection solution CVD & oxidation gases, Doping gases, Etching & chamber cleaning
gases
- Intelligent-Type Gas Detector, having a Built-in Micro processor
- Continuous Measuring of Oxygen & Toxic Gas and Vapours by continuous sampling
- Excellent Measurement Sensitivity and Stability
- Warning Alarm & Fault Relays
- Calibration Maintenance & Normal Measurement Modes
- RS-485 MODBUS communication
- Local FND display
- Control and Set up by key Switch on the Front
- Built-in Subminiature and High-Efficient Micro pump
- 3-wires connection
- 4-20mA Signal output
- Calibration by One Person and Easy Maintenance